Atlona 64 M User Manual

Before making any connections to the AT-COMP-64M, observe the following:
Mains voltage supply must match the label on the supplied plug-Pack (+/- 10%)
Power switch is OFF
All system grounds (earth) must be connected to a common point.
Avoid powering equipment within a system from multiple power sources that may be separated by large 

distances
Connect all audio video sources and destination equipment
Power up all desired sources and destination and displays
For each destination output select the appropriate input source by using the front panel input 1~4 select 

buttons, the supplied IR remote control, or through the RS 232 serial communications port.
Upon power up, the switcher will return to its last used setting before being powered down.

1. SWITCH POWER ON or OFF. 

    Controller with a separate power to turn ON and OFF
 

2.OUTPUT 1 - 4 :  OUTPUT TO TV DISPLAYS. 

   Output -1 :   TV-1   Component Video (YPBPR) HDTV Display  

   Output -2 :   TV-2   Component Video (YPBPR) HDTV Display  

   Output -3 :   TV-3   Component Video (YPBPR) HDTV Display  

   Output -4 :   TV-4   Component Video (YPBPR) HDTV Display
 

3.INPUT 1 - 6 :  INPUT VIDEO SOURCES SELECTION. 

   Input -1 :   AV-1   Component Video (YPBPR) Signal source device 

   Input -2 :   AV-2   Component Video (YPBPR) Signal source device 

   Input -3 :   AV-3   Component Video (YPBPR) Signal source device 

   Input -4 :   AV-4   Component Video (YPBPR) Signal source device 

   Input -5 :   AV-5   Component Video (YPBPR) Signal source device 

   Input -6 :   AV-6   Component Video (YPBPR) Signal source device

4                                                   

  

REMOTE CONTROL