Shindaiwa 82052 User Manual

12

  1.     Stop Switch                                                                        
 

  Move stop switch button (A) away from the STOP position.

  2.  Throttle Position Lever
 

  Move throttle position lever (B) midway between idle and full 

throttle positions.

  3.  Choke
 

  Move choke (C) to Cold Start (

) Position.

  4.  Purge Bulb

      Pump purge bulb (D) until fuel is visible and flows freely in the 

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

Recoil starter:  Use short pulls - only 45 ~ 60 cm (18 ~ 24 in.) of 
rope for starting.  Do not allow the rope to snap back in.  Always 

hold the unit firmly.

  5.  Recoil Starter

    Place the unit on a flat, clear area. Firmly grasp throttle grip with 

left hand and rapidly pull recoil starter handle/rope (E) until 

engine fires (5 pulls maximum).

  6.  Choke

    After engine fires (or 5 pulls), move choke lever (C) to “Run” 
         (

)  position, then pull starter handle/rope until engine starts 

and runs. Allow unit to warm up at idle for several minutes.

If engine does not start with choke in “Run” position after 5 pulls, 
repeat instructions.

  7.  After engine warm up, gradually depress throttle trigger to in-

crease engine RPM to operating speed.