Shindaiwa PB2500 User Manual

7

PB2500.08

PB2500.04

PB08

Grip

Spark

Plug

Main

Shaft

Tube

Clamp

Outer Tube

1. Place the powerhead on a clean, flat

surface, spark plug facing up.
See Figure 5.

2. Use the 4mm hex wrench to loosen

the tube clamp screw. Verify that the
D-shaped shim washer is positioned as
shown in Figure 6.

Tube

Clamp

Shim

Washer

Do not remove the D-shaped shim
washer! The shim washer prevents
damage from overtightening the tube
clamp screw.

Do not force the shaft tube into the
powerhead! Excessive force can
damage the shaft tube or mainshaft.

Clamp

Screw

Throttle

Trigger

Ignition

Switch

Hex

Wrench

3. Add some moly-type EP grease to the

splines on the end of the mainshaft.

4. Slide the outer tube into the tube

clamp until the tube bottoms.

5. Position the outer tube so that the

ignition switch is facing up and the
throttle trigger is down.

6. Slide the outer tube into the power-

head until the throttle grip just
contacts the tube clamp.

7. Tighten the clamp screw firmly.

1.  Loosen the air cleaner cover knob and

remove the air cleaner cover.
See Figure 7.

2. Slip the throttle cable into the cable

adjuster and hook the bullet end of the
cable onto the swivel. See Figure 8.

3. Connect the two ignition wires by

pushing the bullet connectors
together. See Figure 9.

4. Reinstall the air cleaner cover.

Connect the throttle

cable

Ignition

Lead

PB2500.05

PB2500.06

Throttle

Cable

Cable

Adjuster

Filter

Cover

Cable Swivel

Routing of wiring must not interfere
with throttle operation.