Sony MZ-R35 User Manual

If the following error messages flash in the display window, check the chart below.

BLANK DISC

DISC ERR

DISC FULL

BUSY

NAME FULL

Hi DC in

HOLD

LOW BATT

MEM OVER

NO COPY

NO DISC

•An MD with no recording on it is inserted.

b Insert a recorded MD.

•The recorder cannot read the disc (it's scratched or dirty).

b Reinsert or replace the disc.

•There is no more space to record on the disc (less than 12

seconds available).
b Replace the disc.

•You tried to operate the recorder while it was accessing the

recorded data.
b Wait until the message goes out (in rare cases, it may take

2–3 minutes).

•You tried to enter more than 200 characters for a track or disc

name or the total characters entered in an MD is more than
1700.
b Enter the characters within the limit.

•Voltage of the power supply is too high (The supplied AC

power adaptor or the recommended car battery cord is not
used).
b Use the supplied AC power adaptor or the recommended

car battery cord.

•The recorder is locked.

b Slide HOLD against the arrow to unlock the recorder

(page 19).

•Batteries are weak.

b Charge the rechargeable battery or replace the dry

batteries (pages 25, 26).

•You tried to record when there is no indication in the display,

with the recorder placed where it receives continuous
vibration.
b Put the recorder on a stable place, and start recording

again.

•You tried to make a copy from a disc that is protected by the

Serial Copy Management System. You cannot make copies
from a digitally connected source which was itself recorded
using digital connection.
b Use analog connection instead (page 6).

•You tried to play or record with no disc in the recorder.

b Insert an MD.