Nilfisk Alto 91WS User Manual
American-Lincoln
1 - 5
91 WS
MACHINE PREPARATION
Your American-Lincoln Technology sweeper has been shipped complete, but do not attempt to operate before
reading and following the preparation instructions for your type of machine.
Your American-Lincoln Technology sweeper has been shipped complete, but do not attempt to operate before
reading and following the preparation instructions for your type of machine.
GAS/LP POWERED MACHINES
1.
1.
Uncrate the machine and carefully remove it from the skid to prevent damage.
2.
Inspect the machine for obvious damage and check the controls for proper operation.
3.
Connect and tighten battery cables.
4.
Fill fuel tank with regular grade unleaded gasoline.
*Install filled LP tank and connect fuel line to the tank.
*Turn on service valve, check all LP connections for leaks.
*Turn off service valve after inspection has been completed.
*Install filled LP tank and connect fuel line to the tank.
*Turn on service valve, check all LP connections for leaks.
*Turn off service valve after inspection has been completed.
5.
Check engine crankcase oil level. Although properly lubricated at the factory, check before starting engine.
The engine uses no special break in oil. The recommended number of hours before the initial oil change is 5
hours (see maintenance chart).
The engine uses no special break in oil. The recommended number of hours before the initial oil change is 5
hours (see maintenance chart).
6.
For safety, do not operate until you have read the safety precautions and operation instructions in the
manual.
manual.
*=LP Powered machines only
WARNING
To prevent possible fire, never fill fuel tank while the engine is running. Always be sure gasoline container and
sweeper are electrically grounded before dispensing gasoline. This can be done by permanently attaching an
insulated wire with a battery clip on the end to the gasoline container.
WARNING
Keep cigarettes, sparks, and open flame away from LP equipment.
Use extreme caution when inspecting for gas leaks.
MACHINE PREPARATION
C1199
FIGURE 1