Nilfisk Alto ATTIX 965-2H/M SD XC User Manual

26

1) 

Optional accessories / Option depending on model

Original Instructions

ATTIX 9 H/M

‡ Motor does not start

> Fuse of the mains socket has 

blown.

•

Connect mains fuse.

> Overload protection switch 

has tripped.

•

Switch off the vacuum cleaner 
and allow it to cool for approx. 
5 minutes. If the cleaner 
cannot be started again, 
contact the Nilfisk-Alto service 
department.

> Motor is faulty.

•

Have motor changed by 
Nilfisk-Alto Service.

‡ Motor does not run in 

automatic mode 

1)

> Power tool/pneumatic tool is 

defective or not connected 
properly.

•

Check that the power tool 
works or that the plug is 
inserted correctly.

> The power rating of the 

electrical tool is too low.

•

Note that minimum power 
rating is P>40W

‡ The acoustic warning 

sounds. (Reduced suction 
power)

> Suction power selected with 

suction power control is too 
low.

•

Set suction power in 
accordance with section 
„Setting suction power“.

> Hose diameter does not cor-

respond with switch position.

•

Set correct switch position for 
hose diameter.

> Clogged suction hose/nozzle.

•

Clean suction hose/nozzle

> The safety filter bag is full.

•

See section „Replacing the fil-
ter bag“.

> Filter element is clogged.

•

See section „Cleaning filter 
element“ and „Replacing filter 
element“.

> Cleaning mechanism is 

defective.

•

Contact Nilfisk-Alto Service.

‡ No suction power during 

wet cleaning 

> Tank is full. 

•

Switch off the cleaner. Empty 
the tank.

‡ Voltage fluctuations

> Impedance of power supply is 

too high.

•

Connect the cleaner to another 
socket closer to the fuse box. 
Voltage fluctuations over 
7% should not occur if the 
impedance at the transfer point 
is 

0.15 .