Panasonic MC-UL425 User Manual
- 44 -
Replacing Belt
Four Screws
Quatre vis
Cuatro Tornillos
Cuatro Tornillos
➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
slippage occurs.
➢ Turn off and unplug the vacuum
cleaner.
➢ Lay unit on floor bottom up with
nozzle flat.
➢ Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and out of retaining slot
(see REMOVING CLOGS, p. 52).
sliding up and out of retaining slot
(see REMOVING CLOGS, p. 52).
➢ Remove the four screws from the
nozzle cover. Next place the
vacuum in the upright position
standing on the handle. This will
minimize wheel interference when
removing nozzle bottom plate.
Remove nozzle bottom plate by
rotating upward.
vacuum in the upright position
standing on the handle. This will
minimize wheel interference when
removing nozzle bottom plate.
Remove nozzle bottom plate by
rotating upward.
CAUTION
Motor shaft may be hot.
➢ Lay unit on floor bottom up with
nozzle flat.
➢ Remove agitator by carefully lifting
out.
➢ Remove worn or broken belt.
➢ Clean agitator and the end caps
(see CLEANING AGITATOR, p. 48).
Belt
Correa
Courroie
Motor Shaft
Arbre d’entrainement
du moteur
Eje del motor
du moteur
Eje del motor
Agitator
Agitateur
Agitador
Agitador