Pelco FR8301 User Manual

 

C1641M-A  (3/05)

13

 

The following sections provide information about mounting the FR8301 receiver into a rack or 
onto a wall.

 

The FR8301 receiver can be installed into an RK5000 Series rack mount chassis, which can be 
mounted into an industry-standard 19-inch (48.26 cm) equipment rack. The RK5000 Series rack 
mount chassis includes the following models:

•

 

  Designed to accommodate fiber optic modules as 

follows:
–

The RK5000PS-3U rack mount chassis provides 12 module slots and a power 
supply. 

–

The RK5000-3U rack mount chassis provides 14 module slots (a power supply is 
not included). Power to the modules can be supplied using the optional external 
power supply (EPS5000-120).

For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount 
Chassis Installation manual.

•

 

  Designed to accommodate Endura

 

™

 

 modules but can also accommodate 

fiber optic modules with the use of the appropriate adapter kit. The RK5001-1UEXP 
adapter kit is required for installation of the FR8301 receiver into the RK5000PS-5U 
chassis.

For information about the RK5000PS-5U chassis, refer to the RK5000PS-5U Rack Mount 
Chassis Installation manual. 

 

The FR8301 receiver can be mounted to a wall in the following ways:

•

Using the supplied wall clip for attachment of a single module to a wall. For installation 
instructions, refer to the 

 

 section 

below.

•

Using the optional WM5001 wall mount kits, which are designed for mounting of single-
width fiber optic modules. The WM5001-3U base kit allows attachment of a single 
module to the wall. The WM5001-3UEXP expansion kit allows attachment of an 
additional module to the wall. It is recommended that a maximum of three expansion 
kits be used with the base kit, allowing a maximum of four single-width modules to be 
attached to the wall.

 

 The WM5001 wall mount kits can be used with the WM5002 wall mount kits, 

which are designed for mounting of double-width fiber optic modules. If mounting a mix 
of single-width and double-width modules is desired, it is recommended that a 
maximum of two single-width modules and one double-width module be mounted in 
combination with one another.

For mounting instructions using the wall mount kits, refer to the WM5000 Series W all 
Mount Kit Installation manual.