Manualsbrain.com
  1. Manuals
  2. Brands
  3. Sennheiser
  4. EW 300 IEM G3
  5. User Manual

Sennheiser EW 300 IEM G3 User Manual

Download
Page of 30
Using the transmitter
13
Using the transmitter
To establish a transmission link, proceed as follows:
1.
Switch the transmitter on (see below).
2.
Switch the receiver on (see the instruction manual of the receiver).
The transmission link is established.
If you cannot establish a transmission link between transmitter and receiver:
왘
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
왘
Switching the transmitter on/off
To switch the transmitter 
on 
(online operation):
To switch the transmitter to 
standby mode
:
왘
If necessary, deactivate the lock mode (see page 18).
To completely switch the transmitter 
off
:
왘
Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket.
The backlighting of the 
STANDBY 
button
 goes off.
To switch the transmitter 
on
 and to 
deactivate the RF signal on switch-on
 (offline operation):
It is vital to observe the notes on frequency selection on page 21.
왘
Press the 
STANDBY
 button 
.
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
 is displayed
You can switch the transmitter on and deactivate the RF signal on switch-on.
For more information, see below.
왘
Keep the 
STANDBY
 button 
 pressed until “
OFF
” appears on the display panel.
The display panel switches off.
When in the operating menu, pressing the 
STANDBY 
button
 will cancel your entry
(ESC function) and return you to the standard display.
The 
STANDBY
 button
 is backlit in red both during operation and in standby mode.
왘
Press the 
STANDBY
 until “
RF Mute On?
” appears on the display panel.
왘
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit
an RF signal. The transmission icon
 is not displayed.