Manualsbrain.com
  1. Manuals
  2. Brands
  3. Sennheiser
  4. EK 300 IEM G3
  5. User Manual

Sennheiser EK 300 IEM G3 User Manual

Download
Page of 38
Using the devices
16
Using the devices
To establish a transmission link, proceed as follows:
1. Switch the transmitter on.
2. Switch the diversity receiver on.
The transmission link is established.
If you cannot establish a transmission link between transmitter and receiver:
왘
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel – the easiest way is to synchronize the devices (see page 20).
왘
If necessary, read the chapter “If a problem occurs ...” on page 29.
Switching the devices on/off
Switching the SR 300 IEM G3 transmitter on/off
To switch the transmitter 
on 
(online operation):
To switch the transmitter 
on
 and to 
deactivate the RF signal on switch-on
 (offline operation):
To 
activate
 the 
RF signal
:
To switch the transmitter to 
standby mode
:
왘
If necessary, deactivate the lock mode (see page 18).
It is vital to observe the notes on frequency selection on page 27.
왘
Press the 
STANDBY
 button 
.
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
 is displayed.
왘
Press the 
STANDBY
button 
 until “
RF Mute On?
” appears on the display panel.
왘
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit
an RF signal. The transmission icon
 is not displayed. In addition, the display
backlighting changes from orange to red and “
RF Mute
” flashes in alternation
with the standard display.
Use this function to prepare a transmitter for use during live operation without
causing interference to existing transmission links.
왘
Briefly press the 
STANDBY
 button 
“
RF Mute Off
” appears on the display panel.
왘
Press the jog dial. 
The transmission icon
is displayed again.
왘
Keep the 
STANDBY
 button 
 pressed until “
OFF
” appears on the display panel.
The transmitter switches to standby mode.