Wegener Communications 550 User Manual

UICK

TART

UIDE

www.wegener.com

800072-02B

LED Indications after Power-Up

Within approximately 15 seconds of power up, the IRD gives an indication of stable operation. It
initializes all system components and supplies an operational status. A steady

Green

LED indicates

that it is locked on a carrier and is capable of producing output (Audio/Video/Data).

If there is some problem with the IRD or the signal it is receiving the LED flashes

Red

for alarm

conditions or

Amber

for warning conditions. In general, alarms indicate that the unit cannot produce

output, while Warnings indicate that, although output is being produced, there is a problem that could
require attention. The most common conditions that produce alarms or warnings are listed in

Table 3

Table 3: Unity 550

Front Panel Status LED Alarm and Warning Indications

OSD (On-Screen Display)

Although the

Unity 550

is set up at the factory, you can customize its settings to fit your system using

the

OSD

and front-panel buttons. You may also view the existing settings and the various status and

version fields by using the push buttons to navigate through the menus displayed on an attached
monitor.

The

OSD

menus allow you to set up or change settings for these functions:

Carrier Status,

Carrier Select

Software Version information

Signal Strength Monitoring,

Serial Port device selection,

Audio Settings

Data PID settings

OSD Setup

The

OSD

information is contained in a 14-line x 40-character display in the video output from the

Unity 550

receiver. View the

OSD

from a monitor connected to the video monitor output of the

Unity 550

receiver.

1. From the front panel, use the right or left arrow buttons to navigate to

OSD

2. To display the

OSD

on the monitor, press

Enter

NOTE:

To exit the

OSD

, select

EXIT

from the Main Menu on the monitor. When a menu is first shown,

the cursor is always placed on its first field.

Mode

Condition

Status LED

Alarm

Installation Mode

Red Blink = 3

Carrier Table Search

Red Blink = 4

Header Search Mode

Red Blink = 5

Eb/NO Alarm

Red Blink = 7

Not Authorized

Red Blink = 11

Alarm Selected Program not available

Red Blink = 12

Warning

Selected Audio not available at Port 1

Amber Blink = 1

Marginal Eb/NO

Amber Blink = 2

COMPEL Required but No COMPEL in the last 2 minutes

Amber Blink = 3

Selected Audio not available at Port 2

Amber Blink = 4

RF Level Low

Amber Blink = 5

RF Level High

Amber Blink = 6