Sony DWT-P01 User Manual

Setting Menus

The setting for this function cannot be
changed during actual signal transmission.
To change the setting, turn off the
transmitter first. Then, while holding down
the SET button, turn the power on. And
then, change the setting after the signal
transmission has stopped.

Setting the RF output
power

(RF POWER)

You can set the RF output power.

1 mW (LOW): Transmitted by 1 mW
10 mW (MID): Transmitted by 10 mW
50 mW (HIGH): Transmitted by 50 mW

Using wireless remote control, this function
can be controlled from the receiver and
other devices.

For details on wireless remote control function, see
“Using the Wireless Remote Control Function” on
page 20.

Setting the audio input
level

(INPUT LEVEL)

You can set the input level to an analog
head amp.
Select LINE or MIC, depending on the
audio source connected to the audio input
connecter.
When MIC is selected, ATT (attenuation
level) will flash next. With the microphone
connected, speak into the microphone as
you monitor the audio input level meter and
press the + or – button repeatedly to select
the appropriate attenuation level.
The reference levels for the various settings
are as follows:

With the wireless remote control function, the attenuation level can be changed from the
receiver and other devices.

For details on wireless remote control function, see “Using the Wireless Remote Control Function” on page 20.

Note

Input

Attenuation
(dB)

Reference input
level (dB)

Maximum input
level (dBu)

Headroom (dB)

MIC

–58

–22

–

–19

–

–16

–

–13

3 dB step

–

+23

–

+24

LINE

–

+24