Brother V97 User Manual
Winding/Installing the Bobbin 25
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
j
Wind the end of the thread clockwise around
the bobbin five or six times.
While using your left hand to hold the thread
that was passed through the bobbin-winding
thread guide, use your right hand to wind the
end of the thread.
the bobbin five or six times.
While using your left hand to hold the thread
that was passed through the bobbin-winding
thread guide, use your right hand to wind the
end of the thread.
CAUTION
k
Pass the end of the thread through the guide
slit in the bobbin winder seat, and then pull
the thread to the right to cut it.
slit in the bobbin winder seat, and then pull
the thread to the right to cut it.
a Guide slit in bobbin winder seat
(with built-in cutter)
CAUTION
Memo
z Make sure that the thread is correctly set
before starting the bobbin winding.
Otherwise the thread may become tangled
and fail to wind the thread.
Otherwise the thread may become tangled
and fail to wind the thread.
l
l
Slide the sewing speed controller to the right.
a Speed controller
m
Press
(Start/stop button) once.
When the foot controller is plugged in, press
down on the foot controller.
down on the foot controller.
a Start/stop button
X
The bobbin starts winding and "Winding
bobbin thread..." is displayed on the LCD
screen.
bobbin thread..." is displayed on the LCD
screen.
Note
z Do not get away from the machine while
winding the bobbin. Make sure the bobbin
thread is being wound correctly. If the
bobbin thread is wound incorrectly, press
thread is being wound correctly. If the
bobbin thread is wound incorrectly, press
(Start/stop button) or operate the foot
controller immediately to stop the bobbin
winding.
winding.
n
n
When the bobbin winding stops or becomes
slow, press
slow, press
(Start/stop button) once to
stop the machine.
When the foot controller is plugged in, remove
your foot from the foot controller.
When the foot controller is plugged in, remove
your foot from the foot controller.
X
The bobbin winding will stop.
CAUTION
● Be sure to pull the thread tightly and
wind it clockwise. If the thread is
wound counterclockwise, the thread
may wind around the bobbin winder
shaft.
wound counterclockwise, the thread
may wind around the bobbin winder
shaft.
● Be sure to cut the thread as described. If
the bobbin is wound without cutting the
thread using the cutter built into the slit
in the bobbin winder seat, the thread may
become tangled in the bobbin or the
needle may bend or break when the
bobbin thread starts to run out.
thread using the cutter built into the slit
in the bobbin winder seat, the thread may
become tangled in the bobbin or the
needle may bend or break when the
bobbin thread starts to run out.
Wind five or six times.
a
● When the bobbin winding stops or
becomes slow, stop the machine.
Otherwise, the sewing machine may be
damaged.
Otherwise, the sewing machine may be
damaged.
a
a