Brother S-7200C User Manual
S-7200C
10. ADJUSTMENTS
116
Sewing
machine
machine
Table
１０
-２. Adjusting the safety switch position
The safety switch (1) is normally installed as shown in figure
[A].
However, if the processing method used for the table leaves
too much space between the machine head and the table
hole, it may adversely affect the operation of the safety
switch (1).
[A].
However, if the processing method used for the table leaves
too much space between the machine head and the table
hole, it may adversely affect the operation of the safety
switch (1).
<Adjustment method>
The standard amount of clearance between the machine
head and the table hole is 1.5 mm.
If the clearance is 3.5 mm or more, install the safety switch
(1) so that the washer (2) is on the machine head side as
shown in Figure [B].
The standard amount of clearance between the machine
head and the table hole is 1.5 mm.
If the clearance is 3.5 mm or more, install the safety switch
(1) so that the washer (2) is on the machine head side as
shown in Figure [B].
* If the position cannot be satisfactorily adjusted in this way,
add more washers of the same thickness.
<Safety switch operation>
3690M
3691M
3692M
By changing the position of the safety switch,
the required spring stroke can be maintained.
the required spring stroke can be maintained.
Clearance
is too large.
is too large.
If the spring stroke is too small, the safety
switch will not operate.
switch will not operate.
Reduce the clearance.
3.5 mm or more
4249M