Brother BAS-311E Owner's Manual

BAS-311E.311EL.326E.326EL

12.Press the P key and adjust the X-sensor setting plate 

!7 so that the needle !4 is aligned with the home position (X=0,

Y=0) of the H-position standard plate 

!1.

13.Press the P key again to make sure that the needle 

!4 is aligned with the home position (X=0, Y=0) of the H-position

standard plate 

!1.

14.Secure the X-sensor setting plate 

!7 using the screw.

15.Remove the needle 

!4.

16.Press the P key to be out of the program mode, and turn off the power.
17.Replace the H-position standard plate 

!1 with the work clamp.

Note:  When adjusting the X home position, be sure to set the clearance between the X-home position dog 

!8 and the

surface where the sensor is activated to 0.1 - 0.5 mm.  If the clearance is too great, an error in home position
detection may occur because the temperature of the sewing machine rises during sewing operation.

0.1 - 0.5mm

H - position
(X=0, Y=0)

!1

!4

!7

!8