Brother BAS-311E Owner's Manual

BAS-311E.311EL.326E.326EL

■ For vertical wiper (standard)

1. When the thread wiper solenoid plunger 

q is driven to the full stroke, the wiper w should be 15 mm in front of the

needle center. Loosen bolts 

e and shift the entire solenoid bracket r up or down to adjust.

The standard height from the solenoid setting plate 

r bottom to the needle plate top is approximately 112 mm.

2. When the wiper 

w is operated and aligned with the center of the needle bar, the distance from the wiper w to the point

of the needle should be approximately 2 mm. Loose the screw 

t and move the wiper w in or out to adjust. As shown

in Fig. A, make sure the wiper 

w does not strike the presser foot y or the needle.

Note: Make that the wiper 

w is not touching the finger guard.

■ For horizontal wiper (optional)

1. Loosen the set screw 

e and move the wiper arm support r up or down to adjust so that there is a clearance of 15 - 16

mm between the bottom of the thread wiper 

q and the needle plate w when the thread wiper q is aligned with the

center of the needle bar.

2. After the thread wiper has wiped the thread, loosen the bolt 

t and move the solenoid setting plate y up or down to

adjust the distance to approximately 35 mm.

r

q

e

112mm

t

w

w

15 - 16mm

q

w

e
r

(25mm)

(25mm)

(35mm)

(35mm)

y

t

15mm

approximately 2 mm

t

y