Brother BAS-311E Owner's Manual

BAS-311E.311EL.326E.326EL

■ (Y axis) 326E, 326EL

1. Press the P key and adjust the Y-sensor setting plate 

e so that the needle q is aligned with the home position (X=0,

Y=0) of the H-position standard plate 

w.

2. Press the P key again to make sure that the needle 

q is aligned with the home position (X=0, Y=0) of the H-position

standard plate 

w.

3. Attach the Y-sensor setting plate 

e to the Y-home position bracket r using the bolt t.

4. Remove the needle 

q.

5. Press the P key to be out of the program mode, and turn off the power.
6. Replace the H-position standard plate 

w with the work clamp.

Note: When adjusting the Y home position, be sure to set the clearance between the Y-driving shaft 

y and the surface

where the sensor 

u is activated to 0.1 - 0.5 mm.  If the clearance is too great, an error in home position detection

may occur because the temperature of the sewing machine rises during sewing operation.

y

r

t

e

0.1 - 0.5mm

q

w

H - position
(X = 0, Y = 0)

u