Panasonic RP-BTD10 User Manual

VQT5J78

5

With Bluetooth

 enabled phones (cell phones or smartphones) that support the 

“HSP” or “HFP” Bluetooth

 profile, you can use the unit for phone calls.

 

• HSP (Headset Profile):

This profile can be used to receive monaural sounds and establish two-way 
communication using the microphone on the unit.

 

• HFP (Hands-Free Profile):

In addition to the HSP functions, this profile has the incoming and outgoing calls 
function.

 

• During an incoming call, 

ringtone will sound from the 
speaker and the LED will blink.

 

• (HFP only) To reject the 

incoming call, press and hold 
Call 

 until the ringtone stops.

 

 

• Also refer to the operating 

manual for the Bluetooth

 

enabled phone.

 

• During an outgoing call, ringtone 

will sound from the speaker and 
the LED will blink.

 

• To cancel the outgoing call, 

press Call 

. 

A beep will sound.

 

• (HFP only) When the phone is 

idle, press and hold Call 

 for 

approximately 2 seconds. An 
outgoing call will be made to the 
last dialed number. One short 
click will sound from the speaker 
and the LED will blink.

 

• The LED will repeatedly blink 2 times during a call.

 

• The volume can be adjusted during a phone call. For setting instructions, see 

page 4.

 

• A beep will sound.

■

 

• There may be instances when hands free setting needs to be done on the 

Bluetooth

 enabled phone.

 

• Depending on the Bluetooth

 enabled phone, you may hear incoming and 

outgoing call ringtones of the phone from the unit.

 

• (HFP only) Press and hold the Call 

 on the unit for approximately 2 seconds. 

The calling device will be switched between the Bluetooth

 enabled phone and 

the unit.

This unit can be reset when all operations are rejected. Connect the unit to a 
computer using the USB charging cord. Then press the RESET hole with a thin, 
pointed object. Check that the LED (red) goes out. Keep pressing the RESET hole 
(

→ P. 2) for approximately 5 seconds to reset the unit. All the previous operations 

will be canceled. (The pairing device information will not be deleted.)

If the unit is silent for approximately 5 minutes and operations for Bluetooth

 

devices are idle during that period, a beep will sound and the power will be 
automatically turned off.

When the battery level is low during use of the unit, the blue blinking LED on the 
left speaker will change to red. A beep will sound every 1 minute. When the battery 
runs out, the power will turn off.