Sony MDR-EX38IP Leaflet

Page of 2
Stereo 
Headphones
MDR-EX38iP
©2009   Sony Corporation     Printed in Thailand
4-156-141-11(1)
Operating Instructions
Manual de instrucciones
Colored parts
Sectional View
English
Stereo headphones
Features
  Easy-to-use remote control for iPod
only
  Clear and rich sound with deep bass
  Convenient cord adjuster supplied
How to use
Wearing the headphones 
(see fig. )
Wear the earpiece marked  in your
right ear and the one marked  in
your left ear.
There is a tactile dot on the unit
marked  to distinguish the left side.
How to use the cord slider 
(see fig. -)
Move up and down to change the split
position of the cord.
How to use the supplied 
cord adjuster 
(see fig. -)
You can adjust the cord length by
winding the cord on the cord adjuster.
(The cord can be wound to the cord
adjuster up to 50 cm. If you wind
more, the cord comes off from the cord
adjuster easily.)
Wind the cord.
Push cord into slot hole to 
secure in place.
Note
Do not wind the plug or split section of the
cord, as it will strain the cord and may cause
a wire break.
How to use the remote 
and microphone for an 
iPod (See fig. -
You can control a connected iPod
product.
Parts and controls
 Volume +
Increases the volume of the connected
iPod product.
 Center button
Plays/pauses a track of the connected
iPod product with a single press. Skips
to the next track with a double press.
Skips to the previous track with a triple
press. Starts the “VoiceOver*” feature
with a long press (if available).
 Volume –
Decreases the volume of the connected
iPod product.
 Microphone
Compatible products
You can use the unit with the following
models.
  iPod nano (4th generation)
  iPod classic (120 GB)
  iPod touch (2nd generation)
  iPod shuffle (3rd generation)
* Availability of the “VoiceOver” feature
depends on iPod model and its software
version.
How to install the earbuds 
correctly (see fig. )
If the earbuds do not fit your ears
correctly, low-bass sound may not be
heard. To enjoy better sound quality,
change the earbuds to another size, or
adjust the earbuds position to sit on
your ears comfortably and fit your ears
snugly.
If the earbuds do not fit your ears, try
another size. Confirm the size of the
earbuds by checking color inside (see
fig. -).
When you change the earbuds, turn to
install them firmly on the headphones
to prevent the earbud from detaching
and remaining in your ear.
Earbud sizes (inside color)
Small 
Large 
SS
(Red)
(Orange)
(Green)
(Light blue)
* This size is optional and available at
purchase.
To detach an earbud 
(see fig. -)
While holding the headphone, twist
and pull the earbud off.
 Tip
If the earbud slips and cannot be detached,
wrap it in a dry soft cloth.
To attach an earbud 
(see fig. -)
Push the parts inside of the earbud into
the headphone until the projecting
part of the headphone is fully covered.
Cleaning the earbuds
Remove the earbuds from the
headphones, and wash them with a
mild detergent solution.
Specifications
Receiver
Type: 
Closed, dynamic
Driver unit: 
9 mm, dome type (CCAW)
Power handling capacity: 
100 mW (IEC*)
Impedance: 
16 Ω at 1 kHz
Sensitivity: 
100 dB/mW
Frequency response:  
6 – 23,000 Hz
Cord: 
1.2 m (3.9 ft), Litz cord
Y-type
Plug:  
Gold-plated L-shaped stereo
mini plug
Mass: 
Approx. 3 g (0.11 oz)
without cord
Microphone
Open circuit voltage level:  
– 42 dB ( 0dB=1V/Pa)
Supplied accessories
Earbuds (S × 2, M × 2, L × 2)
Cord adjuster (1)
Carrying pouch (1)
* IEC = International Electrotechnical
Commission
Design and specifications are subject
to change without notice.
Precautions
  Please keep your headphones clean
at all times especially inside the
rubber earbud. (see fig. )
If any dust or ear wax inside the
earbud, you may experience some
listening difficulties.
  Listening with headphones at high
volume may affect your hearing. For
traffic safety, do not use while
driving or cycling.
  The earbuds may deteriorate due to
long-term storage or use.
  Install the earbuds firmly onto the
headphones. If an earbud
accidentally detaches and is left in
your ear, it may cause injury.
Note on static electricity 
In particularly dry air conditions, mild
tingling may be felt on your ears. This
is a result of static electricity
accumulated in the body, and not a
malfunction of the headphones.
The effect can be minimized by
wearing clothes made from natural
materials.
EP-EX10A is available (sold
separately) as optional replacement
earbuds.
EP-EX10A offers 4 types of the
earbuds: SS, S, M and L.
On copyright
  iPod is a trademark of Apple Inc.,
registered in the U.S. and other
countries.