Sony RCD-W10 User Manual
Additional Information
31
The sound has a lot of static.
Strong magnetism from a television or a similar
device is interfering with operations. Move the unit
away from any sources of strong magnetism.
device is interfering with operations. Move the unit
away from any sources of strong magnetism.
Other
No sound is output.
• Make the connections properly (page 6).
• Operate the amplifier properly.
• When using the headphones, turn PHONE
LEVEL to turn up the output level.
The remote does not operate the unit.
• Make sure that there are no obstacles between the
unit and the remote.
• Point the remote at the remote sensor on the unit.
• Replace the batteries in the remote.
When you turn on the unit, you will hear some
mechanical noise from the unit. This is not a
malfunction.
mechanical noise from the unit. This is not a
malfunction.
After you have attempted the
prescribed corrective actions
prescribed corrective actions
If the unit still does not operate properly, or if
other problems not described above occur, turn
off the unit, then reinsert the plug into the
power outlet.
other problems not described above occur, turn
off the unit, then reinsert the plug into the
power outlet.
Should any problem persist even after
reinserting the power plug, consult your nearest
Sony dealer.
reinserting the power plug, consult your nearest
Sony dealer.
Troubleshooting
If you experience any of the following
difficulties while using the unit, use this
troubleshooting guide to help you remedy the
problem.
difficulties while using the unit, use this
troubleshooting guide to help you remedy the
problem.
DECK A (the CD player
section)
section)
The player does not start playing.
• Insert a disc.
• Place the disc properly.
• Clean the disc (page 4).
• Place the disc with the label side up.
• Moisture condensation has formed inside the
unit. Take the disc out and leave the unit turned
on for about an hour until the moisture
evaporates (page 4).
on for about an hour until the moisture
evaporates (page 4).
• Press POWER to turn the unit on.
DECK B (the CD-R and CD-RW
recording section)
recording section)
The unit does not operate or operates poorly.
• The CD-R or CD-RW may be damaged. Replace
the disc.
The unit does not play back.
• Place the CD-R or CD-RW with the label side
up.
• Moisture has formed inside the unit. Take the
disc out and leave the unit in a warm place for
several hours until the moisture evaporates (page
4).
several hours until the moisture evaporates (page
4).
• Press POWER to turn the unit on.
• Replace the CD-R or CD-RW with one that has
been recorded.
The unit does not record.
• The CD-R or CD-RW is finalized. Unfinalize
(for CD-RW only) the disc (page 25) and try
again.
again.
• Make connections properly to the sound source
(page 6).
• The sound source is not connected to the selected
input connector. Select the correct input using
the INPUT button (page 20).
the INPUT button (page 20).
• The recording level is set too low. Adjust the
recording level properly (page 21).
• There has been a power failure or the AC power
cord has been disconnected during recording.
Data recorded to that point may be lost.
Data recorded to that point may be lost.