Sony SCD-XE670 User Manual

If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help you remedy the
problem.  Should any problem persist, consult
your nearest Sony dealer.

• Check that the player is connected securely.

• Make sure you operate the amplifier correctly.

• When you use the headphones, adjust the volume

with PHONE LEVEL.

• The audio signals of the super audio CD cannot

be output from the DIGITAL (CD) OUT
OPTICAL connector.

• There is no disc inside the player.

• The disc is placed upside down on the tray.

• Place the disc on the disc tray with the label side

up.

• The disc is placed at an angle. Reload the disc.

• Clean the disc (see page 24).

• Moisture has condensed inside the player.

Remove the disc and leave the player turned on
for about an hour.

• There is an incompatible disc on the tray (see

page 10).

• Remove any obstacles in the path of the remote

and the player.

• Point the remote at the remote sensor on the

player.

• If the batteries in the remote are weak, replace

with new ones.

• Select the playback mode so that the Sub woofer

is set to “a” (page 20).

• When you play a track that does not contain the

LFE signal, the signal outputs from the SUB
WOOFER jack only when you select “5 – Small
+ SW” or “FRT – Large + SW” for the Multi-
channel playback mode (page 21).

Playing frequency range

2 Hz to 100 kHz

Frequency response

2 Hz to 50 kHz (–3 dB)

Dynamic range

103 dB or more

Total harmonic distortion
rate

0.0020 % or less

Wow and flutter

Value of  measurable limit
(±0.001 % W. PEAK) or
less

Frequency response

2 Hz to 20 kHz

Dynamic range

98 dB or more

Total harmonic distortion
rate

0.0025 % or less

Wow and flutter

Value of measurable limit
(±0.001 % W. PEAK) or
less

ANALOG
OUT

DIGITAL
(CD) OUT
OPTICAL*

PHONES

*Output only the audio signals of the CD

Laser:

Semiconductor laser
(SACD: 

λ

 = 650 nm)

(CD: 

λ

 = 780 nm)

Emission duration: continuous

Power requirements

230 V AC, 50/60 Hz

Power consumption

26 W

Dimensions (w/h/d)

430 

×

 95 

×

 285 mm

incl. projecting parts

Mass (approx.)

3.9 kg

See page 6.

Design and specifications are subject to change
without notice.

Over 10
kilohms

Wave
length:
660 nm

32 ohms

Phono
jacks

Square
optical
output
connector

Stereo
phone
jack

2 Vrms
(at 50 kilohms)

–18 dBm

10 mW