Sony CDP-XA30ES User Manual
Additional Information
27
EN
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the LINE OUT/
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the LINE OUT/
PHONE LEVEL control.
The CD does not play.
/There’s no CD inside the player. Insert a CD.
/Use the stabiliser.
/Place the CD with the label side up on the disc
/Use the stabiliser.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 26).
/Moisture has condensed inside the player.
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 26).
for about an hour (see page 26).
The recording level has changed.
/When you connect the amplifier via the
VARIABLE LINE OUT jacks, the recording level
changes if you adjust the LINE OUT/PHONE
LEVEL control on the player or press LINE
OUT LEVEL on the remote during recording.
changes if you adjust the LINE OUT/PHONE
LEVEL control on the player or press LINE
OUT LEVEL on the remote during recording.
The remote does not function.
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output
Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ±0.3 dB
Dynamic range
More than 100 dB
Harmonic distortion
CDP-XA50ES: Less than 0.0017 %
CDP-XA30ES: Less than 0.0018 %
CDP-XA30ES: Less than 0.0018 %
Outputs
LINE OUT
(FIXED)
(FIXED)
LINE OUT
(VARIABLE)
(VARIABLE)
DIGITAL
OUT
(OPTICAL)
OUT
(OPTICAL)
DIGITAL
OUT
(COAXIAL)
OUT
(COAXIAL)
PHONES
General
Power requirements
Where purchased
Europe
Other countries
Power consumption
CDP-XA50ES: 20 W
CDP-XA30ES: 20 W
CDP-XA30ES: 20 W
Dimensions (approx.)
CDP-XA50ES: 430
×
125
×
375 mm
(w/h/d)
(17
×
5
×
14 7/8 in.) incl. projecting
parts
CDP-XA30ES: 430
CDP-XA30ES: 430
×
125
×
350 mm
(17
×
5
×
13 7/8 in.) incl. projecting
parts
Mass (approx.)
CDP-XA50ES: 15.2 kg (33 lbs 8 oz)
CDP-XA30ES: 9.0 kg (19 lbs 13 oz)
CDP-XA30ES: 9.0 kg (19 lbs 13 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Stabiliser (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Stabiliser (1)
Design and specifications are subject to change without notice.
Power requirements
220 V – 230 V AC, 50/60 Hz
CDP-XA50ES 220 V – 230 V AC, 50/60 Hz
CDP-XA30ES 110 V – 120 V or 220 V – 240 V
AC, adjustable, 50/60 Hz
Maximum
output
level
output
level
2 V
(at 50 kilohms)
(at 50 kilohms)
2 V
(at 50 kilohms)
(at 50 kilohms)
–18 dBm
0.5 Vp-p
(75 ohms)
(75 ohms)
28 mW
Jack
type
type
Phono
jacks
jacks
Phono
jacks
jacks
Optical
output
connector
output
connector
Coaxial
output
connector
output
connector
Stereo
phone
jack
phone
jack
Load
impedance
impedance
Over 10 kilohms
Over 50 kilohms
Wave length: 660 nm
75 ohms
32 ohms
Additional Information