Viking SLCS User Manual
fIGURE 25
To increase the pre-load add shims to position A.
To decrease the pre-load remove Shims from position A.
See section 6.2 for pre-load settings.
To decrease the pre-load remove Shims from position A.
See section 6.2 for pre-load settings.
POsITION a
fIGURE 26
4.06
fIGURE 24
fIGURE 23
5.13
5.06
5.09
5.05
SECTION TSM 288
ISSUE
A
PAGE 14 OF 36
• Install the casing (3.01) onto the bearing housing (4.01) and
use the bolts (4.07) to secure the casing (3.01)
NOTE: Without the gearbox cover spacers may be required to
ensure the casing is fully clamped in position
NOTE: The pre-load must be set one shaft at a time.
When the pre-load is set remove the gear and install the gear
When the pre-load is set remove the gear and install the gear
keys (5.07)
This procedure must be repeated for the second shaft
This procedure must be repeated for the second shaft
4.1.3 CasING assEMblY
• Install the dowels (4.06) into the bearing housing
(See Figure 26)
4.1.2 ROllING TORQUE /
PRE-lOad
Use a torque meter to check the rolling torque see section 6.2
for torque settings.
If the rolling torque is under / over the required amount add /
If the rolling torque is under / over the required amount add /
remove shims to adjust the pre-load to suit (See section 6.2
Fasteners & Torque Settings).
NOTE: Rolling torque can only be set on new bearings, with no
NOTE: Rolling torque can only be set on new bearings, with no
sealing devices installed i.e. lip-seals or O-rings.
When checking the rolling torque is it important to make sure
When checking the rolling torque is it important to make sure
the shaft is rotating freely, completely rotate the shaft 10 times
before checking the rolling torque.
The pre-load is set by adding or removing shims in position A
The pre-load is set by adding or removing shims in position A
(See Figure 25).
Install 0.25 mm (0.009”) of shims (5.13) , pre-load spacer
(5.05), gear (5.06) and locknut (5.09)
NOTE: Do not install the gear key or tab washer at this time
When setting the pre-load on the shafts note the pre-load has to
NOTE: Do not install the gear key or tab washer at this time
When setting the pre-load on the shafts note the pre-load has to
be set on individual shafts, so only install one gear at a time.