Sony KV-32FV16 User Manual

The remote control is preset to operate Sony brand video equipment.

If you have video equipment other than Sony brand that you want to 
control with the TV’s remote control, use the following procedures to 
program the remote control. 

Turn to “Manufacturer’s Codes” on page 53, and find the three-digit 
code number for the manufacturer of your component. If more than 
one code number is listed, use the number listed first to complete the 
following procedure.

Move the slide switch to the desired component type (KV-32FV26 
and KV-36FV26 models only). (Skip this step if you are 
programming a cable box or satellite receiver.)

Press 

CODE SET

.

Press the function button for the type of component you want to 
control with the TV’s remote control (VTR/DVD or SAT/
CABLE). 

Enter the three-digit manufacturer’s code number.

Press 

ENTER

.

To check if the code number works, aim the TV’s remote control 
at the component and press the green POWER button that 
corresponds with that component. If it responds, you are done. If 
not, try using the other codes listed for that manufacturer.

Beta, ED Beta VCRs

VTR1 

303

8 mm VCR

VTR2 

302

VHS VCR

VTR3 

301

DVD Player

DVD/MDP 

751

✍

The equipment must have infrared (IR) remote capability in order to be used 
with the remote control.

✍

You must perform step 3 within 10 seconds of step 2, or you must start 
again from step 2.

 

❑

If more than one code 
number is listed, try 
entering them one by 
one until you come to 
the correct code for 
your component.

❑

If you enter a new code 
number, the code 
number you 
previously entered at 
that setting is erased.

❑

In some rare cases, you 
may not be able to 
operate your 
component with the 
supplied remote 
control. In this case, 
use the component’s 
own remote control 
unit.

❑

Whenever you remove 
the batteries to replace 
them, the code 
numbers may revert to 
the factory setting and 
must be reset.

z