Bogen UDMS16HH User Manual

1. Install batteries by unscrewing the BATTERY. COMPARTMENT. COVER. (28).

....

counterclockwise and remove, exposing the BATTERY.HOLDER.(26). Insert two

fresh AA. ALKALINE. BATTERIES. (27), observing the correct polarity, and

screw the cover back on to the microphone. Make sure the cover is screwed

clockwise completely. Fresh alkaline batteries can last up to 10 hours in use,

but in order to ensure optimum performance, it is recommended that you

replace the batteries after every 7-8 hours of use.
2. Select Channel by turning the frequency rotary DIP.SWITCH.(20) to one of

the sixteen channels. The slot on the switch shaft should match a number or letter of

the dial, which indicates the selected channel. This channel needs to be set to

the same channel as the UDR16 Receiver.

(IMPORTANT NOTE: The transmitter

must be OFF when selecting a new channel. When selected, the transmitter will then be

at the new selected channel when turned ON. If you attempt to change the channel

when the transmitter is ON, it will not change until the unit is turned OFF and ON

again. This step must be repeated each time you select a new channel.)

3. Turn on the UHT16 by sliding the AUDIO.MUTE.SWITCH.(21) to the OFF position first.

Then slide the POWER.SWITCH.(22) to the ON position. The TX LED.INDICATOR.(green)

....(23)

will stay on to indicate that the transmitter is on. The BATTERY.INDICATOR.

.......LED.

(red).(24) will stay OFF, indicating usable

battery strength. In the case of a dead

or low battery, the BATTERY. INDICATOR.

. . . LED. (24)

will either not go on at all or

will stay on continuously, indicating

that the batteries should be replaced with

fresh ones. To preserve battery life, turn

the transmitter off when not in use.
4. The microphone is now ready to use. The

A or B DIVERSITY.LED.INDICATOR.(14) on the

UDR16 receiver should now be lit, indicating

a received signal from the transmitter. When

ready to speak, slide the AUDIO.SWITCH.(21).

..........

to the ON position. (Note: Observe care in selecting P.A. volume, transmitter location

and speaker placement so that acoustic feedback (howling or screeching) will

be avoided.) (Note: The windscreen of the UHT16 functions as a built-in antenna.

For proper operation, never remove the windscreen during use, or exchange with

another type. For optimum range, maintain line-of-sight between the transmitter

and the receiver whenever possible. Holding the microphone tightly, bridging

across the windscreen and mic tube, will also lessen range. Hold mic by mic

tube housing only for optimum operation.)
5. For optimum performance, an INPUT.LEVEL.CONTROL.(25) is provided. Adjust

the gain by turning the control with a small screwdriver. It is recommended

that the level be set at about 1/2 maximum. Experiment and set for maximum

possible gain without audible distortion on the high level peaks. (Note: Turning

down the gain too much can compromise the signal-to-noise ratio, and is not

recommended.)

UHT16.HANDHELD.MICROPHONE.TRANSMITTER

24 23