BlueAnt Wireless none Owner's Manual

Advanced Functions

Driver to Passenger or Bike to Bike INTERCOM
The BLUEANT INTERPHONE has motorcycle intercom system that allows driver
to passenger conversations. This intercom features full-duplex communication so
driver and passenger may enjoy simultaneous conversations just like on the
telephone. To use this feature you must have two BlueAnt InterPhone Headsets

Intercom Pairing Procedure:

1. Prepare two BLUEANT INTERPHONES.
Note: Make sure to switch off the phones paired to these two headsets.
2. Set the two units to pairing mode (from off, press and hold the MFB(1) of the

BLUEANT INTERPHONE for about 5 seconds or until you hear the 2

beep).

3. When the two are set to pairing, press Volume Up(3) button of BLUEANT

INTERPHONE N°1 for about 5 seconds (1

beep followed by 5 successive

beeps will be heard and then BLUEANT INTERPHONE N°1 turns off).

4. Wait for 3 seconds and then switch on BLUEANT INTERPHONE N°1.
5. Press Volume Down(4) button of BLUEANT INTERPHONE N°2 for about 5

seconds (1

beep followed by 5 successive beeps will be heard). BLUEANT

INTERPHONE N°2 pairing blink will change to blinking blue while BLUEANT
INTERPHONE N°1 will again turn off.

6. Wait for 3 seconds and then switch on again BLUEANT INTERPHONE N°1.
7. Press MFB(1) of BLUEANT INTERPHONE N°1 for about 3 seconds (2

beep) to connect to BLUEANT INTERPHONE N°2.

   The set-up has been successful. Both headsets are now connected. Full-
   duplex conversations can be made.
Note: This has to be done only once every time you want to use 2 different
   BLUEANT INTERPHONE together.

Using as an Intercom:

To switch from phone to intercom, press MFB(1) for 3 seconds or until

you hear the 2

beep.

To switch from intercom to phone, press MFB(1) for 1 second or until

you hear the 1

beep.

Important

Notes:

1. Both BLUEANT INTERPHONES’ must be in intercom mode to allow

intercom.

2. When the BlueAnt Interphones go out of range of each other they will

drop out of intercom mode and will need to be manually reconnected
when back in range. This is done by simply pressing and holding the MFB