Panasonic RX-ES29 User Manual
15
RQT7912
Troubleshooting
Before requesting for service, make the following checks. If you cannot fix the unit as described below, or if something not listed
here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
Reference pages are shown as an example (
here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
Reference pages are shown as an example (
l 3).
Common problems
CD
Cassette deck
Radio
Remote Control
Technical Specifications
Radio
Frequency range
FM
87.50
s108.00 MHz (50 kHz steps)
AM
522
s1629 kHz (9 kHz steps)
CD player
Sampling frequency 44.1
kHz
Decoding
16 bit linear
Beam source
Semiconductor laser (wavelength 780 nm)
Bølgelengde
780 nm
Laserstyrke
Ingen farlig stråling sendes ut
No. of channels
2-channel, stereo
Wow and flutter
Below measurable limit
D/A converter
MASH (1 bit DAC)
Tape recorder
Track system Stereo
Monitor system
Monitor system
Variable sound monitor
Recording system
AC bias
Erasing system
Multi Pole magnet
Frequency range
Normal position
50
s14000 Hz
General
Speakers
(RX-ES29) 8 cm 5.4
™ k 2
(RX-ES23) 8 cm 2.7
™ k 2
Jacks
Output
PHONES: 3.5 mm stereo (16
s32 ™)
Power requirement
AC
230
s240 V, 50 Hz
Power consumption: (RX-ES29) 30 W
(RX-ES23) 23 W
Battery
12 V [Eight R20/LR20 (D, UM-1) batteries]
≥ Do not use rechargeable type batteries.
Memory back-up for computer/clock
6 V [Four R6/LR6 (AA, UM-3) batteries]
≥ Do not use rechargeable type batteries.
Dimensions
529 mm (W)
k 144 mm (H) k 276 mm (D)
Mass
(RX-ES29) 4.4 k
g without batteries
(RX-ES23) 3.9 k
g without batteries
Notes:
≥
Specifications are subject to change without notice.
≥
Mass and dimensions are approximate.
“E” is displayed.
Indicates incorrect operation. Read the instructions.
“U01” is displayed.
Replace the batteries or use household AC power. (
l 6)
“U02” is displayed.
Power batteries have not been inserted. Insert them or use household AC power.
(
(
l 6)
CD will not play or CD display is
incorrect.
incorrect.
Place the CD with label facing up. (
l 8)
Wait for 1 hour for condensation to dry and try again.
Certain sections are not played
properly.
properly.
Clean the CD. (
l 3)
Replace the CD if it is scratched, warped, or nonstandard.
Recording is not possible.
If the cassette’s tabs have removed, cover the holes with adhesive tape. (
l 10)
Poor sound quality.
Clean the heads. (
l 3)
A lot of noise or tuning difficulty.
Interference may be caused by other equipment or the use of its remote control.
Turn the other equipment off or keep this unit away from them.
Turn the other equipment off or keep this unit away from them.
The remote control does not work.
Check to ensure the batteries are inserted correctly. (
l 4)
Replace the batteries if they are worn. (
l 4)
The unit cannot be turned on from
the remote control.
the remote control.
Turn the unit on from the main unit if you are using batteries to power the unit.
(
(
l 4, 6)
Power consumption in standby mode
(RX-ES29) 2.7 W
(RX-ES23) 2.3 W
(RX-ES23) 2.3 W
E_EB_GN_RQT7912-B.book 15 ページ ２００４年１２月８日 水曜日 午後４時１５分