Panasonic WJ-ND400 User Manual
Using the Front Panel for Operations
46
You can install HDDs from the recorder while it is in operation.
1
Insert the key (included) into the key hole and turn it to
the right while pressing gently to open the front cover.
the right while pressing gently to open the front cover.
2
Insert the HDD units into the HDD bay slots while
checking each HDD number marked on the HDD bay
slots.
Press the HDD unit's removal knob down and lift the lever,
and then insert it all the way into the disk slot.
checking each HDD number marked on the HDD bay
slots.
Press the HDD unit's removal knob down and lift the lever,
and then insert it all the way into the disk slot.
(1)
Hook the HDD unit's tab securely on the
HDD bay slot.
HDD bay slot.
(2)
Press the lever down and push the HDD
unit until the removal knob clicks.
unit until the removal knob clicks.
3
The HDD is automatically recognized.
•
While the HDD is being recognized, the HDD status
indicator blinks orange.
indicator blinks orange.
Once the HDD is recognized, the HDD status indicator
lights green or blinks.
lights green or blinks.
•
The HDD is automatically formatted if it is not
preformatted.
preformatted.
The HDD status indicator lights green after formatting is
complete.
complete.
•
Preformatted HDDs are recognized for playback only. In
this case, the HDD status indicator blinks green. Follow
the instructions from step 4 to use the HDD for recording.
this case, the HDD status indicator blinks green. Follow
the instructions from step 4 to use the HDD for recording.
Note:
•
The HDD status indicator may light green before blinking
orange when an HDD is inserted.
orange when an HDD is inserted.
4
Press the [USE] button for over 2 seconds.
A buzzer sounds.
Press the front panel buttons according to the directions on
the LCD.
A buzzer sounds.
Press the front panel buttons according to the directions on
the LCD.
5
Press the arrow buttons (up or down) on the front panel
until [HDD Operate] appears on the screen.
until [HDD Operate] appears on the screen.
6
Press the [SET] button.
7
Press the arrow buttons (up or down) on the front panel
until [Link HDD] appears on the screen.
until [Link HDD] appears on the screen.
8
Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
then press the [SET] button.
9
Select the device where you installed the HDD
(Recorder: MAIN, Extension unit x: EXTx) with the arrow
buttons (up or down) and press the [SET] button.
(Recorder: MAIN, Extension unit x: EXTx) with the arrow
buttons (up or down) and press the [SET] button.
10
Select the device where you installed the HDD with the
arrow buttons (up or down) and press the [SET] button.
arrow buttons (up or down) and press the [SET] button.
Installing HDDs
(1)
(2)
(1)
(1)
(2)
ND400_Basic.book 46 ページ ２００８年４月８日 火曜日 午後３時５９分