Panasonic C5310U User Manual

Page of 26
50
CQ-C5410/5310/5210/5110U
CQ-C5410/5310/5210/5110U
51
Caution:
≥ This unit operates with a 12 V DC 
negative ground auto battery system only. 
Do not attempt to use it in any other system. 
Doing so could cause serious damage.
    WARNING
This installation information is 
designed for experienced installers 
and is not intended for non-technical 
individuals. It does not contain 
warnings or cautions of potential 
dangers involved in attempting to 
install this product.
Any attempt to install this product in 
a motor car by anyone other than a 
qualifi ed installer could cause damage 
to the electrical system and could result 
in serious personal injury or death.
If your car is equipped with air bags 
and/or anti-theft systems specifi c 
procedures may be required for 
connection and disconnection of the 
battery to install this product. 
Before attempting installation of this 
electronic component contact your car 
dealer or manufacturer to determine 
the required procedure and strictly 
follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE 
MAY RESULT IN THE UNINTENDED 
DEPLOYMENT OF AIR BAGS OR 
ACTIVATION OF THE ANTI-THEFT 
SYSTEM RESULTING IN DAMAGE TO 
THE VEHICLE AND PERSONAL INJURY.
No.
Item
Diagram Q’ty
1 Mounting collar
1
2 Hex. nut (5 mm
‡)
1
3 Rear support strap
1
4 Tapping screw
(5 mm
‡k16 mm)
1
5 Mounting bolt 
(5 mm
‡)
1
6 Power connector
1
7 Trim plate
1
8 Lock cancel plate
2
Overview
This product should be installed by a professional. 
However, if you plan to install this product yourself, 
your fi rst step is to decide where to install it. The 
instructions in these pages will guide you through 
the remaining steps: 
(Please refer to the “WARNING” statement.)
≥ Identify and label the car wires.
≥ Connect the car wires to the wires of the power 
connector.
≥ Install the unit in the dashboard.
≥ Check the operation of the unit.
If you encounter problems, please consult your 
nearest professional installer.
Before you begin installation, look for the items 
which are packed with your unit.
≥ Warranty Card... Fill this out promptly.
≥ Panasonic Servicenter List for Service 
Directory... Keep for future reference in case the 
product needs servicing.
≥ Installation Hardware... Needed for in-dash 
installation.
Installation Hardware
12 V DC 
Test bulb
Electrical tape
Side-cut 
pliers
Dashboard Specifi cations
Thickness  Min. 
3
/
16
q (4.75 mm)
Max. 
7
/
32
q (5.56 mm)
7
5
/
32
q (182 mm)
2
3
/
32
q (53 mm)
Installation Guide
E
N
G
L
I
S
H
31
E
N
G
L
I
S
H
32
Required Tools
You’ll need a screwdriver, a 1.5 V AA battery, and 
the following:
Preparation
≥ We strongly recommend that you wear gloves 
for installation work to protect yourself from 
injuries.
≥ When bending the mounting tabs of the 
mounting collar with a screwdriver, be careful 
not to injure your hands and fi ngers.
≥ Disconnect the cable from the negative - battery 
terminal (see caution below).
≥ Unit should be installed in a horizontal position 
with the front end up at a convenient angle, but 
not more than 30
o.
Less than 30
o
Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having 
an opening as shown above. The dashboard should 
be 
3
/
16
q (4.75 mm)–
7
/
32
q (5.56 mm) thick in order to 
be able to support the unit.
2
3
/
32
q (53 mm)
7
5
/
32
q (182 mm)
Note:
 Various settings that have been stored in the 
memory in other on-board equipment (car 
navigation etc.) may be lost if the battery 
terminals are disconnected.
Therefore, we recommend to make a record of 
or to back up the settings before disconnecting 
the terminals. 
After completing installation of the main unit, 
set the equipment again according to the 
record.
Caution:
 If your car is equipped with air bags and/or 
anti-theft systems specifi c procedures may 
be required for connection and disconnection 
of the battery to install this product. 
 Before attempting installation of this 
electronic component contact your car 
dealer or manufacturer to determine the 
required procedure and strictly follow their 
instructions.
 FAILURE TO FOLLOW THE PROCEDURE MAY 
RESULT IN THE UNINTENDED DEPLOYMENT 
OF AIR BAGS OR ACTIVATION OF THE 
ANTI-THEFT SYSTEM RESULTING IN DAMAGE 
TO THE VEHICLE AND PERSONAL INJURY.