Philips AZ 1060 User Manual

11

1. Select RADIO source.
™ The function indication lights up. 

is displayed briefly

and then the radio station frequency is shown.

2. Press BAND once or more to select your waveband.
3. Press SEARCH

∞ or § and release when the frequency in

the display starts running.

™ The radio automatically tunes to a station of sufficient

reception. Display shows 

during automatic tuning.

™ If a FM station is received in stereo, 

is shown.

4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH

∞ or § briefly and

repeatedly until you have found optimal reception.

To improve radio reception
– For FM, pull out the telescopic antenna. Incline and turn the

antenna. Reduce its length if the signal is too strong (very
close to a transmitter).

– For AM, the set is provided with a built-in antenna so the

telescopic antenna is not needed. Direct the antenna by
turning the whole set.

5. To switch off, adjust the POWER slider to TAPE/

position

with the keys on the tape deck released.

™ The function indicator goes out.

Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
– Display: 

flashes.

3. Press PRESET 

4 or 3 once or more to allocate a number from

1 to 30 to this station.

4. Press PROG again to confirm the setting.
– Display: 

disappears, the preset number and the

frequency of the preset station are shown.

5. Repeat the above four steps to store other stations.
– You can erase a preset station by storing another frequency in

its place.

Tuning to preset stations
Press PRESET 

4 or 3 until the desired preset station is

displayed.

AZ 1060 /17  

page

11

XP AZ 1060/17  30-11-2000 11:06  Pagina 11