Philips AZ 6188 User Manual

21

"

NO DISC" is displayed

– Insert a disc and check if the disc is upside down.
– Wait until the moisture condensation at the lens has

cleared.

– Replace or clean the disc, see "Maintenance"
– Use a readable disc or an MP3-CD recorded in the

correct format.

Radio reception is poor

– If the signal is too weak, adjust the antenna for better

reception.

– Increase the distance between the Receiver and your

TV or VCR.

Recording or playback cannot be made – Clean deck parts, see "Maintenance".

– Use only NORMAL (IEC I) tape.
– Apply a piece of adhesive tape over the missing tab

space.

The system does not react when the  –

Slide the source selector to TAPE/OFF. Remove the 

buttons are pressed /The set does not  

AC power plug and reconnect it 30 seconds later

work / No display on LCD.

and then switch on the system again.

Sound cannot be heard or is of poor

– Adjust the volume.

quality

– Make sure the MP3-CD was recorded within 32-320

kbps (128kbps preferably) with sampling frequencies
at 8 - 48 kHz (44.1kHz preferably).

Loop, Follow or Compare is not available – Check if the language learning mode is activated. Press

and hold MODE until LANG ON appears on the
display.Then the    language learning is activated.

The set does not break sentences

– The CD disc may be scraped. Please replace the disc 

automatically

with a new one.

– If in the tape mode, the tape quality may be poor.

Please use a good tape.

The playing speed cannot be changed

– The playing speed can be changed only in the

language learning mode.

– Please activate Loop, Follow or Compare function in

the language learning mode first.

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable
to remedy a problem by following these hints, consult your dealer or service centre.

AZ6188_01_Eng(NEW)  4/22/04  16:52  Page 21