Philips CDR-600 User Manual

Page of 28
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
1
Connect a digital coaxial cable between the DIGITAL IN-
and OUT sockets on the set and e.g. the (digital) AUX in-
and output sockets on the digital receiver.
Any digital device, connected to the digital input sockets
of the digital receiver (e.g. CD and DVD) can now be
used as recording source.
Power supply/Mains
1
Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does not,
consult your dealer or service organisation.
2
Make sure all connections have been made before
switching on the mains supply.
3
Plug the power cord supplied into the AC MAINS ~
connector and the CD recorder, then into the wall socket.
4
Press ON/OFF.
The CD recorder will switch on.
Notes:
If the CD recorder is in Standby mode (red LED on),
press any key to activate the recorder.
When the CD recorder is in the “OFF” position, it is still
consuming some power. If you wish to disconnect your 
CD recorder completely from the mains, withdraw the plug
from the AC Outlet.
CD RECORDER
1
DIGITAL
RECEIVER
1
CD RECORDER
DIGITAL
IN
OUT
OPTICAL
IN
ANALOG
IN
L
R
L
R
OUT
CDR
Installation
13
English
xp CDR 600/00_01 English  06-04-2001 18:19  Pagina 13