Philips MG9218 User Manual
9
POWER SUPPLY/EARPHONES
Use only the supplied AY 3170 adapter (4.5 V/300 mA
direct current, positive pole to the center pin). Any other
product may damage the player.
direct current, positive pole to the center pin). Any other
product may damage the player.
1 Make sure that the local voltage corresponds to the
power adapter´s voltage.
2 Connect the power adapter to the 4.5V DC jack
of the player and to the wall power outlet.
Note: Always disconnect the adapter when you are not using it.
• Connect the supplied earphones to the LINE OUT/p
jack.
Note: LINE OUT/p can also be used for connecting your
HiFi system (signal lead) or your car radio
(cassette adapter or signal lead). In both cases,
the volume of the player must be set to position 8.
(cassette adapter or signal lead). In both cases,
the volume of the player must be set to position 8.
0
H
O
LD
LINE
OUT/
VOL.
Earphones
4,5V DC
Power adapter
(supplied )
Use your head when using earphones
Hearing safety: Do not play your earphones at a high volume. Hearing experts
advise that continuous use at high volume can permanently damage your hearing.
Hearing safety: Do not play your earphones at a high volume. Hearing experts
advise that continuous use at high volume can permanently damage your hearing.
Traffic safety: Do not use earphones while driving a vehicle. It may create a hazard
and it is illegal in many countries. Even if your earphones are an open-air type
designed to let you hear outside sounds, do not turn up the volume so high that you
cannot hear what is going on around you.
and it is illegal in many countries. Even if your earphones are an open-air type
designed to let you hear outside sounds, do not turn up the volume so high that you
cannot hear what is going on around you.
MG9218/17 eng 8/25/00 4:47 PM Page 9