Philips AQ414 User Manual

1  Check if the power voltage, as shown on

the type plate located on the 
bottom of the set, corresponds to your
local power supply. If it does not, consult 
your dealer or service center.

2  If your set is equipped with a voltage 

selector, adjust the selector so that it 
matches with the local mains.

3  Connect the power cord to the AC IN ~

inlet and the wall socket.The power cord is
now connected and ready for use.

4  To switch the set off completely, withdraw

the power cord from the wall socket.

•

Disconnect the power cord from the wall
socket to protect your set during heavy 
thunderstorms.

Helpful hints : To avoid unnecessary energy
consumption, always adjust the Source
selector to TAPE (OFF) after using the
set. Also check that the tape deck keys are
released.

1  To switch on, push the Source selector

slider to TAPE or RADIO as desired.

2  To switch off, push the Source selector

to TAPE and check the cassette 
keys are released.

Helpful hints:
– To change from TAPE to RADIO , or when

you are switching off the set: first, make sure 
you press the STOP•EJECT

9/ key to end 

•

Adjust the volume with the VOLUME
control.

1  Adjust the source selector to RADIO.

Adjust the band selector to select your
desired waveband, MW, SW or FM.

Turn TUNING to tune to a station.
•In SW, turn TONE for precise tuning.

To switch off the radio, adjust the source
selector to TAPE position.

•

For FM and SW, extend and turn the 
telescopic antenna for best reception.
Reduce its length if the signal is too strong.

•

For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.