Ridgid K-40G PF User Manual

7

5. Secure autofeed to guide hose using the four (4)

screws provided with the autofeed.

1. Make sure the Drain Cleaning Machine is unplugged

and the directional switch is set to the OFF position.

2. Make sure the foot switch is present and attached to

the Drain Cleaning Machine (Figures 10 and 11).
Do not use the Drain Cleaning Machine until one
has been installed properly.

3. Electrical components:

K-40 Drain Cleaner:
Inspect the power cord, Ground Fault Circuit Inter-
rupter (GFCI) and plug for damage. If the plug has
been modified, is missing the grounding pin or if the
cord is damaged, do not use the Drain Cleaning
Machine until the cord has been replaced.

K-40 Battery Charger:
Inspect the power cord and plug for damage. If the
cord or plug is damaged, do not use the charger until
the cord is replaced. Inspect charger for damage.
Do not use charger if it has received a sharp blow,
been dropped or otherwise damaged.

4. Inspect the Drain Cleaning Machine for any broken,

missing, misaligned or binding parts as well as any
other conditions which may affect the safe and normal
operation of the machine. If any of these conditions are
present, do not use the Drain Cleaning Machine until
any problem has been repaired.

5. Lubricate the Drain Cleaning Machine and the guide

hose, if necessary, according to the Maintenance
Instructions.

6. Use accessories that are designed for your drain

cleaner and meet the needs of your application. The
correct accessories allow you to do the job success-
fully and safely. Accessories suitable for use with
other equipment may be hazardous when used with
this drain cleaner.

7. Clean any oil, grease or dirt from all equipment han-

dles and controls. This reduces the risk of injury due
to a tool or control slipping from your grip.