Lenco Autoradio + CD + MP3 CS-172 BT CS172BT User Manual

3

• Choose the mounting location where 

the unit will not interfere with the 
normal driving function of the driver.

• Before finally installing the unit, 

connect the wiring temporarily and 
make sure it is all connected up 
properly and the unit and the system 
work properly.

• Use only the parts included with the 

unit to ensure proper installation. The
use of  unauthorized parts can 
cause malfunctions.

• Consult with your nearest dealer if 

installation requires the drilling of holes
or other modifications of the vehicle.

• Install the unit where it does not get in

the driver’s way and cannot injure the
passenger if there is a sudden stop, 
like an emergency stop.

• If installation angle exceeds 30˚ from 

horizontal, the unit might not give its 
optimum performance.

• Avoid installing the unit where it would

be subject to high temperature, such 
as from direct sunlight, or from hot air,
from the heater, or where it would be 
subject to dust, dirt or excessive 
vibration.

This unit can be properly installed either
from “Front” (conventional DIN Front-
mount) or “Rear” (DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis).

For details, refer to the following
illustrated installation methods.

Before install the unit, please remove the
two screws.

Installation Opening
This unit can be installed in any dashboard
having an opening as show below:

Installing the unit
Be sure you test all connections first, and
then follow these steps to install the unit.
1. Make sure the ignition is turned off,

and then disconnect the cable from
the vehicle battery's negative (-)
terminal.

2. Disconnect the wire harness and the

antenna.

3. Press the release button on the front

panel and remove the control panel
(see the steps of “using the detachable
front panel”).

4. Lift the top of the outer trim ring then

pull it out to remove it.

5. The two supplied keys release tabs

inside the unit's sleeve so you can
remove it. Insert the keys as far as they
will go (with the notches facing up) into
the appropriate slots at the middle left
and right sides of the unit. Then slide
the sleeve off the back of the unit.

30˚

182 mm

53 mm

Take out screw before installation