Magnetek MST E User Manual
Chapter 11.0: Long Term Storage
11.1:
11.1:
If a brake assembly will not be installed immediately, it can be stored indoors in a dry location
indefinitely or outdoors for a reasonable time if adequately protected from moisture and corrosive
atmosphere. The brake assembly must always be protected from direct exposure to the
elements unless specifically treated at the factory for use in that environment. Covering with
plastic sheeting is not acceptable unless provision is made to prevent condensation under the
plastic.
indefinitely or outdoors for a reasonable time if adequately protected from moisture and corrosive
atmosphere. The brake assembly must always be protected from direct exposure to the
elements unless specifically treated at the factory for use in that environment. Covering with
plastic sheeting is not acceptable unless provision is made to prevent condensation under the
plastic.
11.2:
During storage, rust may form on the surface of the brake wheel. This is not usually a problem
with ductile iron wheels nor is it necessary to clean the wheel before placing the wheel in service.
The first few brake applications will polish the wheel.
with ductile iron wheels nor is it necessary to clean the wheel before placing the wheel in service.
The first few brake applications will polish the wheel.
11.3:
Steel wheels may form scale when corroded, and the braking surface may have to be re-
machined to remove the scale. See Table 4 for machining limits. Dynamic balance may be
affected.
machined to remove the scale. See Table 4 for machining limits. Dynamic balance may be
affected.
11.4:
Before painting a brake, protect all pivot points, pull-rod, actuator piston, brake wheel and linings,
etc.
etc.
11.4.(a): Data plates and labels must not be removed or painted over.
8/17/2006
Page 33 of 33
MST/E Electric Shoe Brakes Manual
560022-R6