Conair Water/Spray Tanks User Manual

Water/Spray Tanks

UGE014/0999

Normal operation of the WT/ST tank involves extended expo-
sure of many components to minerals and other water system
contaminants. These minerals and contaminants can produce
deposits, scales, slime or algae that will reduce tank perfor-
mance. 

To maintain the best performance, you should follow this
maintenance schedule and develop an effective water treat-
ment program.

●

● Weekly, or as often as needed.

Gaskets at the ends of the tank should be kept in good
condition.  Replace any gaskets that are excessively
worn, cracked or torn.

Remove any particles and wipe all surfaces thoroughly.

●

● Monthly

Lubricate not only the grease fittings but coat shafts 
and other sliding surfaces with a seize-resistant bearing
compound to prevent corrosion.  You may need to 
lubricate more often than monthly.

If you have the optional recirculation system, remove
any particles and wipe all surfaces thoroughly.

Check for clogged holes. Rinse or use compressed air to
remove blockage.

●

● Quarterly (every 3 months)

❒

❒  

Refer to manufacturer’s instructions. Recheck pump
alignment after  performing any maintenance that
requires moving the unit.

●

● Every 6 months

Check for loose wires, burned contacts, and signs of
overheated wires. Check exterior power cords to the
main power source and from the electrical box to the
pumps. Check the ground wire. Replace any wire that
appears damaged or has worn or cracked insulation.