GE CC-SCSTAT User Manual
SmartCommand Thermostat
Installation Manual
4
Thermostat control screen
The Thermostat control screen (Figure 2) is the default display screen normally displayed on the WDU.
Figure 2. Thermostat control screen
Temperature display
The WDU will normally display the current temperature from the internal digital temperature sensor or a
remote sensor. The sensors have an accuracy of ± 1°F (± 0.5°C). The WDU will display temperatures from -40
to 190°F (-40 to 88°C). If averaging remote sensors are attached, the display will show the average temperature
of all attached averaging sensors.
remote sensor. The sensors have an accuracy of ± 1°F (± 0.5°C). The WDU will display temperatures from -40
to 190°F (-40 to 88°C). If averaging remote sensors are attached, the display will show the average temperature
of all attached averaging sensors.
Setpoint display
The heating and cooling setpoints are displayed next to the Up and Down buttons. In heat mode, the Up and
Down buttons change the heat setpoint. In cool mode, they change the cooling setpoint. When in auto mode,
the buttons change the last call’s heating or cooling setpoint. The setpoints will push each other if they are
adjusted to within the minimum heat/cool separation (delta T) setting. This setting is default set to 4 degrees,
but can be changed in the installer settings.
Down buttons change the heat setpoint. In cool mode, they change the cooling setpoint. When in auto mode,
the buttons change the last call’s heating or cooling setpoint. The setpoints will push each other if they are
adjusted to within the minimum heat/cool separation (delta T) setting. This setting is default set to 4 degrees,
but can be changed in the installer settings.
Clock display
The current time is displayed in the upper left corner of the main screen. Set the clock from the
75
MODE
FAN
MENU
76 H
Econ
Sys Off
Run
No Msg
No Msg
10:25 AM
Outside 60
RUN
74 C
Clock
display
Setpoint
Display
Display
Up
Down
Fan
Run/Hold
LED
Display
Mode
Menu