Yamaha HTR-6180 User Manual
61
En
XM Satellite Radio tuning
BA
S
IC
OPERA
T
ION
English
■ All Channel Search mode
1
Press B
SEARCH MODE (or ISRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
SEARCH”.
2
Press E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
• You can search for a channel quickly by pressing and holding
EPRESET/TUNING/CH l / h (or 8PRESET/CH k / n).
• To display the XM Radio ID number displayed in the front
panel display, select channel “0”.
■ Category Search mode
1
Press B
SEARCH MODE (or ISRCH
MODE) repeatedly to select “CAT SEARCH”.
2
Press D
CATEGORY (or 8A-E/CAT. l / h)
repeatedly to change the channel category.
3
Press E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
category.
y
You can search for a channel quickly by pressing and holding
EPRESET/TUNING/CH l / h (or 8PRESET/CH k / n).
You can search for a channel quickly by pressing and holding
EPRESET/TUNING/CH l / h (or 8PRESET/CH k / n).
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see “Setting the XM Satellite Radio preset
channels” on page 62.
mode, you must preset XM Satellite Radio channels. For
details, see “Setting the XM Satellite Radio preset
channels” on page 62.
y
The initial factory setting of all preset channels (A1 to E8) is “001
Preview”.
The initial factory setting of all preset channels (A1 to E8) is “001
Preview”.
1
Press B
SEARCH MODE (or ISRCH
MODE) repeatedly to select “PRESET
SEARCH”.
SEARCH”.
2
Press D
CATEGORY (or 8A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
group (A to E).
3
Press E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (6).
■ Direct number access mode
1
Press I
SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
“CAT SEARCH”.
2
Press the numeric buttons (6) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (6) as shown below.
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (6) as shown below.
y
• To enter a one-digit or two-digit channel number, press the
• To enter a one-digit or two-digit channel number, press the
numeric buttons (6) on the remote control and then press
HENT to confirm the input number.
HENT to confirm the input number.
• Instead of pressing HENT to tune into the channel
immediately, you can wait a few seconds until this unit
confirms the entered channel number.
confirms the entered channel number.
• Pressing a button other than the numeric buttons (6) or HENT
cancels the Direct Number Access mode procedure.
Before performing the following operations, set the operation
mode selector on the remote control to FSOURCE and then
press 4XM.
mode selector on the remote control to FSOURCE and then
press 4XM.
1
2
3