Yamaha RX-V561 User Manual
13
En
Connections
English
PRE
P
ARA
T
ION
■ Before connecting to the SPEAKERS
terminal
A speaker cord is actually a pair of insulated cables
running side by side. Cables are colored or shaped
differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (red)
terminals of this unit and your speaker. Connect the plain
cable to the “–” (black) terminals.
running side by side. Cables are colored or shaped
differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (red)
terminals of this unit and your speaker. Connect the plain
cable to the “–” (black) terminals.
Remove approximately 10 mm (3/8”) of insulation
from the end of each speaker cable and then
twist the bare wires of the cable together to
prevent short circuits.
from the end of each speaker cable and then
twist the bare wires of the cable together to
prevent short circuits.
■ Connecting to the SPEAKERS terminals
1
Loosen the knob.
2
Insert the bare end of the speaker wire into
the hole on the terminal.
the hole on the terminal.
3
Tighten the knob to secure the wire.
Connecting the banana plug
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables. First, tighten the
knob and then insert the banana plug connector into the
end of the corresponding terminal.
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables. First, tighten the
knob and then insert the banana plug connector into the
end of the corresponding terminal.
1
Make sure this unit is turned off.
See page 21 for details about turning on or off this
unit.
See page 21 for details about turning on or off this
unit.
2
Press and hold 0
TONE CONTROL and
then press 1
STANDBY/ON to turn on this
unit.
This unit turns on, an the advanced setup menu
appears in the front panel display.
This unit turns on, an the advanced setup menu
appears in the front panel display.
3
Press A
PROGRAM l / h repeatedly to
select “SP IMP.”.
The following display appears in the front panel
display.
The following display appears in the front panel
display.
4
Press B
STRAIGHT repeatedly to select “6
Ω
MIN”.
The following display appears in the front panel
display.
The following display appears in the front panel
display.
5
Press 1
STANDBY/ON to confirm your
selection and set this unit to the standby
mode.
mode.
The setting you made is reflected next time you turn on this unit.
10 mm (3/8”)
1
2
3
Red: positive (+)
Black: negative (–)
Black: negative (–)
Banana plug
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to “6
Ω
MIN” as follows BEFORE using this unit.
Note
S P
I M P . - 8
M I N
S P
I M P . - 6
M I N