Yamaha RX-V561 User Manual
Optimizing the speaker setting for your listening room
24
En
This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.
• Be advised that it is normal for loud test tones to be output
during the “AUTO SETUP” procedure.
• To achieve the best results, make sure the room is as quiet as
possible while the “AUTO SETUP” procedure is in progress. If
there is too much ambient noise, the results may not be
satisfactory.
there is too much ambient noise, the results may not be
satisfactory.
y
You can run “AUTO SETUP” using the system menu that appears
in the OSD or in the front panel display. This manual uses the
OSD illustrations to explain the “AUTO SETUP” procedure.
You can run “AUTO SETUP” using the system menu that appears
in the OSD or in the front panel display. This manual uses the
OSD illustrations to explain the “AUTO SETUP” procedure.
1
Make sure of the following check points
before starting the AUTO SETUP operations.
❏
before starting the AUTO SETUP operations.
❏
Speakers are connected appropriately.
❏
Headphones are disconnected from this unit.
❏
This unit and the video monitor are turned on.
❏
The connected subwoofer is turned on and the
volume level is set to about half way (or slightly
less).
volume level is set to about half way (or slightly
less).
❏
The crossover frequency controls of the
connected subwoofer is set to the maximum.
connected subwoofer is set to the maximum.
❏
FRONT A speakers are selected as the front
speaker system (see page 33).
speaker system (see page 33).
❏
The room is sufficiently quiet.
2
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
to the OPTIMIZER MIC jack on the front
panel.
The following display appears in the OSD.
3
Place the optimizer microphone at your
normal listening position on a flat level
surface with the microphone heading
upward.
normal listening position on a flat level
surface with the microphone heading
upward.
y
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears would be
when you are seated in your listening position. You can use the
attached screw of a tripod (etc.) to fix the optimizer microphone
to the tripod (etc.).
It is recommended that you use a tripod (etc.) to affix the
optimizer microphone at the same height as your ears would be
when you are seated in your listening position. You can use the
attached screw of a tripod (etc.) to fix the optimizer microphone
to the tripod (etc.).
Optimizing the speaker setting for your listening room
Using AUTO SETUP
Notes
Y
TUNING AUTO/MAN'L
OPTIMIZER MIC
AUDIO SELECT
VIDEO
L AUDIO R
VIDEO AUX
USB
Optimizer
microphone
microphone
AUTO:MENU
SETUP
;;;;;;;AUTO
. START
Automatic
processing
of all item
[ ]/[ ]:Up/Down
[ENTER]:Start
processing
of all item
[ ]/[ ]:Up/Down
[ENTER]:Start
p
p
Optimizer microphone