Yamaha RX-V561 User Manual

• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If a warning message “W-1” appears, corrections are made, but they may not be optimal.
• If a warning message “W-2” or “W-3” appears, no corrections are made.
• If an error message “E-6” occurs repeatedly, please contact a qualified Yamaha service center.

E-1:NO FRONT SP

Front L/R channel signals are not detected.

Check the front L/R speaker connections.

12

E-2:NO SUR.SP

A surround channel signal is not detected.

Check the surround speaker connections.

12

E-3:NOISY

Background noise is too loud.

Try running “AUTO SETUP” in a quiet 
environment.

—

Turn off noisy electric equipment like air 
conditioners or move them away from the 
optimizer microphone.

—

E-4:NO MIC

The optimizer microphone was unplugged 
during the “AUTO SETUP” procedure.

Connect the supplied optimizer microphone 
to OPTIMIZER MIC jack on the front 
panel.

24

E-5:USER CANCEL

The “AUTO SETUP” procedure was 
cancelled due to user activity.

Run “AUTO SETUP” again. 

24

E-6:INTERNAL ERROR

An internal error occurred.

Run “AUTO SETUP” again.

24

W-1:OUT OF PHASE

Speaker polarity is not correct. This 
message may appear depending on the 
speakers even when the speakers are 
connected correctly.

Check the speaker connections for proper 
polarity (+ or –).

12

W-2:OVER 24m (80ft)

The distance between the nearest speaker 
and the furthest speaker is out of adjustable 
range.

Bring the speaker closer to the listening 
position.

—

W-3:LEVEL ERROR

The difference of volume level among 
speakers is excessive. (No level correction 
is made.)

If “SWFR:TOO LOUD” or “SWFR:TOO 
LOW” appears, adjust the output volume of 
the subwoofer.

24

Readjust the speaker installation so that all 
speakers are set in locations with similar 
conditions.

—

Check the speaker connections.

12

Use speakers of similar quality.

—