Yamaha RX-V463 User Manual
25
En
Optimizing the speaker setting for your listening room
English
PREP
ARA
TION
4
Make sure that “SETUP” is set to “AUTO”
and the pointer is pointing at “START”.
and the pointer is pointing at “START”.
y
You can also select the following setup methods. In this
case, press 8
k
to select “SETUP”, press 8 l / h to
select the one of the following choices and then select
“START”.
“START”.
Choices: AUTO, RELOAD, UNDO, DEFAULT
• Select “AUTO” to automatically run the entire
• Select “AUTO” to automatically run the entire
“AUTO SETUP” procedure.
• Select “RELOAD” to reload the last “AUTO
SETUP” settings and override the previous
settings.
settings.
• Select “UNDO” to undo the last “AUTO SETUP”
settings and restore the previous settings.
• Select “DEFAULT” to reset the “AUTO SETUP”
parameters to the initial factory settings.
“RELOAD” or “UNDO” is available only when you have
previously run “AUTO SETUP” and confirmed the results.
previously run “AUTO SETUP” and confirmed the results.
5
Press 8n to select “START” and then press
8
8
ENTER to start the setup procedure.
The following message appears in the OSD.
6
Press 8
ENTER to start the setup
procedure.
This unit starts the auto setup procedure. Loud test
tones are output from each speaker during the auto
setup procedure. Once all items are set, the result
display appears in the OSD.
This unit starts the auto setup procedure. Loud test
tones are output from each speaker during the auto
setup procedure. Once all items are set, the result
display appears in the OSD.
• During the auto setup procedure, do not perform any
operation on this unit.
• We recommend getting out of the room while this unit is in
the auto setup procedure. It takes approximately 3 minutes
for this unit to complete the auto setup procedure.
for this unit to complete the auto setup procedure.
This unit performs the following checks:
Speaker wiring/volume level
WIRING/LEVEL
Checks which speakers are connected and the
polarity of each speaker. Also checks and adjusts the
volume level of each speaker.
polarity of each speaker. Also checks and adjusts the
volume level of each speaker.
Speaker distance
DISTANCE
Checks the distance of each speaker from the
listening position and adjusts the timing of each
channel.
listening position and adjusts the timing of each
channel.
Speaker size
SIZE
Checks the frequency response of each speaker and
sets the appropriate low-frequency crossover for each
channel.
sets the appropriate low-frequency crossover for each
channel.
Note
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure. For more accurate
measurements, keep quiet and move to the wall where
speakers are not around. We recommend that you leave
the listening room during the automatic setup
procedure.
Once you perform the next operation, this unit starts the
automatic setup procedure. For more accurate
measurements, keep quiet and move to the wall where
speakers are not around. We recommend that you leave
the listening room during the automatic setup
procedure.
NOTICE
output.
Loudtesttonesare
Pleasekeepquiet
orleavetheroom.
orleavetheroom.
Press[ENTER]
Notes
01EN_RX-V463_U.book Page 25 Friday, February 1, 2008 11:43 AM