Yamaha RX-V463 User Manual

■ Supplied accessories

Check that you received all of the following parts.

❏ Remote control
❏ Batteries (2) (AAA, R03, UM-4)
❏ Optimizer microphone
❏ AM loop antenna
❏ Indoor FM antenna

■ VOLTAGE SELECTOR 

■ Installing batteries in the remote control

• Change all of the batteries if you notice that the operation range 

of the remote control decreases.

• Do not use an old battery and a new one together.
• Do not use different types of batteries (such as alkaline and 

manganese batteries) together. Read the packaging carefully as 
these different types of batteries may have the same shape and 
color.

• If the batteries have leaked, dispose of them immediately. Avoid 

touching the leaked material or letting it come into contact with 
clothing, etc. Clean the battery compartment thoroughly before 
installing new batteries.

• Do not throw away batteries with general house waste; dispose 

of them correctly in accordance with your local regulations.

• If the remote control is without batteries for more than 2 

minutes, or if exhausted batteries remain in the remote control, 
the contents of the memory may be cleared. When the memory 
is cleared, insert new batteries and set up the remote control 
code.

Yamaha and the Electronic Industries Association’s Consumer 
Electronics Group want you to get the most out of your 
equipment by playing it at a safe level. One that lets the sound 
come through loud and clear without annoying blaring or 
distortion – and, most importantly, without affecting your 
sensitive hearing.

Since hearing damage from loud sounds is often 
undetectable until it is too late, Yamaha and the 
Electronic Industries Association’s Consumer 
Electronics Group recommend you to avoid 
prolonged exposure from excessive volume levels.

The VOLTAGE SELECTOR on the rear panel of this 
unit must be set for your local voltage BEFORE 
plugging the power cable into the AC wall outlet. 
Improper setting of the VOLTAGE SELECTOR may 
cause damage to this unit and create a potential fire 
hazard.

Rotate the VOLTAGE SELECTOR clockwise or 
counterclockwise to the correct position using a 
straight slot screwdriver.
Voltages are as follows:
Asia model ...................  220/230–240 V AC, 50/60 Hz
General model 

...................... 110/120/220/230–240 V AC, 50/60 Hz

01EN_RX-V463_U.book  Page 3  Friday, February 1, 2008  11:43 AM