Yamaha RX-A2010 User Manual
En
117
■
Audio Output
Selects a device to output audio.
• The “Amp” and “HDMI OUT1” settings are available only when “HDMI Control” is set to “Off”.
❑ Amp
Enables/disables the audio output from the speakers connected to this unit.
Settings
❑ HDMI OUT1, HDMI OUT2
Enables/disables the audio output from a TV connected to the HDMI OUT 1 jack or
HDMI OUT 2 jack.
HDMI OUT 2 jack.
Settings
■
Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when this
unit is in standby mode.
unit is in standby mode.
Settings
• This setting is available only when “HDMI Control” is set to “Off”.
Network
Configures the network settings.
■
IP Address
Configures the network parameters (IP address, etc).
❑ DHCP
Select whether to use a DHCP server.
Settings
❑ Manual Setup
Configures the network parameters of this unit manually when “DHCP” is set to “Off”.
Submenu
Off
Disables the audio output from the speakers.
On (default)
Enables the audio output from the speakers.
Off (default)
Disables the audio output from the TV.
On
Enables the audio output from the TV.
Off (default)
Does not output videos/audio to the TV.
On
Outputs videos/audio to the TV.
(This unit consumes approximately 3 W of power.)
(This unit consumes approximately 3 W of power.)
Off
Does not use a DHCP server. Configure the network parameters
manually.
manually.
On (default)
Uses a DHCP server to automatically obtain the network parameters (IP
address, etc.) of this unit.
address, etc.) of this unit.
IP Address
Specifies an IP address.
Subnet Mask
Specifies a subnet mask.
Default Gateway
Specifies the IP address of the default gateway.
DNS Server (P)
Specifies the IP address of the primary DNS server.
DNS Server (S)
Specifies the IP address of the secondary DNS server.