Yamaha RX-A2010 User Manual

En

When “Multi Position” is set to “No”, follow the procedure below to 
make the measurement.

• YPAO measurement is not performed correctly when any obstacles are in the 

room.

• During the measuring process (about 3 minutes), keep stuff in the corners or 

remove it from the room.

The measurement will start in 10 seconds. Press ENTER 
again to start the measurement immediately.

• To cancel the measurement, press RETURN.

The following screen appears on the TV when the 
measurement finishes.

• If any error message (such as E-1) or warning message (such as W-1) 

appears, see “Error messages” (p.49) or “Warning messages” (p.50).

• To check the measurement results, select “Result”. For details, see 

The corrected speaker settings are applied.

• To finish the measurement without saving the result, select “CANCEL”.

Now optimization of the speaker settings is complete.

• Since the YPAO microphone is sensitive to heat, do not place the microphone 

in any place where it will be subjected to direct sunlight or high temperatures 
(top of an AV equipment, etc).