Yamaha RX-V475 User Manual

Page of 112
PREPARATIONS
➤ Connecting speakers
En
16
Connecting speaker cables
Speaker cables have two wires. One is for connecting 
the negative (-) terminal of the unit and the speaker, and 
the other is for the positive (+) terminal. If the wires are 
colored to prevent confusion, connect the black wire to 
the negative and the other wire to the positive terminal.
a Remove approximately 10 mm (3/8”) of insulation from 
the ends of the speaker cable and twist the bare wires of 
the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side 
(upper right or bottom left) of the terminal.
d Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China, Australia and General models only)
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
Connecting the subwoofer 
(with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
Connecting front speakers that 
support bi-amp connections
(RX-V575 only)
When using front speakers that support bi-amp 
connections, connect them to the FRONT jacks and 
SURROUND BACK/BI-AMP/ZONE B jacks.
To enable the bi-amp function, set “Power Amp Assign” 
(p.71) in the “Setup” menu to “BI-AMP” after connecting 
the power cable to an AC wall outlet.
• The FRONT jacks and SURROUND BACK/BI-AMP/ZONE B jacks 
output the same signals.
Connecting Zone B speakers
(RX-V575 only)
The Zone A/B function allows you to playback an input 
source in the room where the unit is installed (Zone A) 
and in another room (Zone B). To connect the Zone B 
speakers, see “Playing back music in multiple rooms 
(RX-V575 only)” (p.61).
FR
ONT
a
a
b
d
c
+ (red)
- (black)
FRO
NT
a
b
Banana plug
PRE OUT
SUBWOOFER
AUDIO
MONITOR OUT
Y
AV
OUT
1
2
AV6
Audio pin cable
1
2
3
4
5
9
FRONT
CENTER
SURROUND
SINGLE
SURROUND BACK/BI AMP
/ZONE B
SPEAKERS
The unit (rear)
Caution
• Before making bi-amp connections, remove any brackets or 
cables that connect a woofer with a tweeter. Refer to the 
instruction manual of the speakers for details. If you are not 
making bi-amp connections, make sure that the brackets or 
cables are connected before connecting the speaker cables.
• Surround back speakers cannot be used during bi-amp 
connections.
1 2
Speaker connections
3 4 5 6 7 8 9 10