Yamaha RX-V1600 User Manual

You can change the name of the input source that appears 
in the display window on the remote control if you want to 
use a different name than the factory preset. This is useful 
when you have set the input selector to control a different 
component.

source component you want to rename.
The selected component name appears in the display 
window.

If you do not complete each of the following steps within 30 
seconds, the renaming mode will be automatically canceled. 
In this case, press RE-NAME again.

Press k / n to select and enter a character.
Pressing n changes the character as follows: 
A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon), 
/ (slash), and space. 
(Pressing k changes the characters in reverse order.)

Press l / h to move the cursor to the next 
position.

Press ENTER to set the new name.
OK appears in the display window if renaming was 
successful.
NG appears in the display window if renaming was 
unsuccessful. In this case, start over from step 4.

y

If you continuously want to rename another component, 
press the input selector button or SELECT k / n to select 
the component, then repeat steps 4 through 6.

ERROR appears in the display window if you press a button not 
indicated in the respective step, or when you press more than one 
button simultaneously.

RE-NAME

RE-NAME