Yamaha RX-V661 User Manual

y

Before performing operations, set the operation mode selector on 
the remote control to KAMP.

y

See page 40 to display the input source information.

Rotate the I

INPUT selector (or press one 

of the input selector buttons (A)) to select 
the desired input source.

The name of the currently selected input source 
appears in the front panel display for a few seconds.

y

The corresponding input selector button on the remote 
control for the currently selected input source lights up for 
approximately 5 seconds after you press any buttons on the 
remote control, showing which source component is 
currently being operated.

Start playback on the selected source 
component or select a broadcast station.
• Refer to the operating instructions for the source 

component.

• See page 50 for details about tuning instructions.
• See page 54 for details about XM Satellite Radio 

tuning instructions.

Rotate 0

VOLUME (or press JVOLUME +/

–) to adjust the volume to the desired output 
level.

y

• See page 48 to adjust the level of each speaker.
• This does not affect the AUDIO OUT (REC) level.
• You can set the initial volume level and maximum volume 

level (see page 77).

Rotate the D

PROGRAM selector (or press 

one of the sound field program selector 
buttons (P) repeatedly) to select the desired 
sound field program.
The name of the selected sound field program appears 
in the front panel display. See page 42 for details 
about sound field programs.

Sound field programs cannot be selected when the 
component connected to the MULTI CH INPUT jacks is 
selected as the input source (see page 38).

y

• Choose a sound field program based on your listening 

preference, not merely on the name of the program.

• When you select an input source, this unit automatically 

selects the last sound field program used with the 
corresponding input source.

• To display information about the currently selected sound 

field program in the OSD, see page 61 for details.

Caution
Extreme caution should be exercised when you play 
back CDs encoded in DTS. If you play back a CD 
encoded in DTS on a DTS-incompatible CD player, 
you will only hear some unwanted noise that may 
damage your speakers. Check whether your CD player 
supports CDs encoded in DTS. Also, check the sound 
output level of your CD player before you play back a 
CD encoded in DTS.

y

To play DTS-encoded CDs when using a digital audio 
connection, set “DECODER MODE” in “INPUT MENU” to 
“DTS” before the playback (see page 80).

INPUT:DVD

Sci-Fi